Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
1.2 h
2 plates
Open in Bambu Studio
Boost
5
25
1
0
48
30
Released
Description
Had to adapt the original to fit my own pole which was quite a bit thinner. So this one supports poles from 33mm to 31mm.
It uses the same 1/4x20 threaded bolt of the original, I have included them in the print file. I have them sliced and horizontally placed, you can either glue them before threading or just thread them without glue which is what I did. Printing lengthwise gives added strength to the bolt so it should not snap easily. All that said it is plastic after all so please do not use too much force when trying to tighten it!
Used standard bambulab PLA for this one and worked perfectly.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)