AR-15 Magwell Vertical Wall Mount | WallMag V

UPDATE: Now Remixable! New License (CC BY-NC-SA 4.0)

This AR-15 vertical wall mount is designed for strength, security, and convenient rifle storage. It positions your AR-15 muzzle-up with the magwell facing the wall, providing a space-saving, vertical display while keeping your firearm readily accessible.

The mount features two vertically aligned holes—both angled for easier installation. Enhanced rigidity comes from 8 perimeter walls and a reinforced set of walls around an internal void. For best results, print laying flat on its top side (as shown in the print profile) to optimize strength and load resistance. PLA is plenty strong for this application, though fiber reinforced filaments can be used to further increase structural integrity if desired. That being said, they're not necessary for most installs.

A built-in magazine release catch locks the lower receiver securely in place.

Mounting holes are 5 mm in diameter with countersunk faces. Recommended hardware (minimum length):

• Drywall to stud: 3" screws
• Direct to stud or slatwall: 2½" screws

Minimal supports were incorporated, and any leftover material in the screw pockets can be left in place as they won't affect install. Perfect for both secure storage and vertical display.

If you prefer a traditional mount that displays your AR-15 from the side, take a look at my other model, "AR-15 Magwell Wall Mount | WallMag"

If you enjoy this model, consider sending a boost—your support helps inspire future designs.