Popcorn Bucket Scout Woggle (No AMS)

This is a popcorn bucket shaped scout woggle for your neckerchief.  The diameter of the hole at the center is 21mm.

Update 1:

Uploaded a new print profile that contains a Medium and a Small hole size for the inner most red piece.  If the 21mm hole is too large for your neckerchief, try one of the smaller hole sizes instead.

Easy to print without any supports and an AMS is not required.  Each color is separated on different build plates. 

Assembly Instructions:

Glue is not required, but can be used throughout the steps below to make the assembly permanent.

Step 1: Slot the red and white stripes together.

Step 2: Press down on the red part until it clicks into place.  When done correctly, the top should be perfectly flat.

Step 3: Insert the 3 yellow dowels into the holes at the top of the red part.  The flat part of the dowels can point in any direction.

Step 4: Place the white ring on top aligning the three holes so that the yellow dowels pop through.  The white ring should have the rounded edge curling downward.  The white ring will click in place around the base white and red striped bucket.

Step 5: Finally align the 3 holes on the bottom of the popcorn top with the 3 dowels and press down until everything clicks together in-place.

Assembly complete!  I hope you enjoy this model.

If you are interested in other models that scouts may like, then visit my Scouts | Collection - MakerWorld: Download Free 3D Models