Super Lube Mount for Honeycomb Storage Wall
Remixed by
Copyright Claim
Super Lube Mount for Honeycomb Storage Wall
Remixed by
Boost
6
20
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
Open in Bambu Studio
Boost
6
20
9
0
32
20
Released
Description
I really liked the idea of being able to keep my tube of Super Lube on the wall but after printing HSW - Super Lube Grease Tube Holder and knocking it down many times I decided to recreate it giving it a much more snug insert. The insert portion does sit slightly above the build plate when printed flat so a small amount of support material is going to be needed.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
It printed right I was wrong. I was putting it in the wrong place on the board. I was trying to use a single spacer when it was a different one that I was supposed to use.
(Edited)
The designer has replied
0
Reply
What was not flat about it? No one else had reported issues, are you sure it didn't warp?
0
Reply
Replying to @sushibagel
It was my mistake. I changed my Rating to five stars. It works wonderful.
0
Reply
Replying to @user_3794991475
thanks for updating it glad it worked out?
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
its OK. Just isn't the best fit for my purpose. I keep my lube with nozzle attached so obviously your design isn't the best fit lol
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld