Map from the Princess Bride - Hueforge Print

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm. If you're willing to do some maths, you can reduce print times by using a layer height modifier to print the base layers at a taller height.

I printed this on a 0.4 nozzle, which sacrificed a bit of the detail in the lettering. You might be able to get away with a 0.2 nozzle but it might take a lot longer. This was a17 hour print on a 0.4 nozzle.

Filaments Used:

• PETG JAYO Black Transmission Distance: 0.3
• PLA+ eSun Grey Transmission Distance: 1.4
• PLA Sunlu Beige Transmission Distance: 8.2
• PETG JAYO White Transmission Distance: 6

Swap Instructions:

• Start with Black
• At layer #20 (0.92mm) swap to Grey
• At layer #22 (1mm) swap to Beige
• At layer #25 (1.12mm) swap to White for the rest.

If you like my work and would like to support me, you can now subscribe to a Thangs membership plan!, or if you prefer, my Patreon.

Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.