Tolerance Test - easy & fast, only 2g filament
Print Profile(1)
Description
It would be great if you follow me 💚💚💚 |
This is a quick and easy tolerance test that requires just over 2g of filament. After less than 15 minutes, you will know the minimum distance (0.10, 0.15, 0.20 or 0.25mm) between two components without them being permanently connected to each other.
A standard cross-head screwdriver is sufficient to loosen the slightly stuck inserts. If the inserts cannot be loosened, the tolerance is too small.
The results for a good clibrated printer should be:
- 0.25 can be freely rotated after printing
- 0.20 can be easily loosened with your fingers
- 0.15 can be easily loosened with a standard cross-head screwdriver
- 0.10 it is usually not possible to loosen the rotating part
Membership
You are welcome to become a member - either to be a sponsor my work or to sell prints of ZiMADE models as a commercial member.
Boost Me (for free)
Please support my free of charge models. A 🚀boost🚀 for a model is like applause for an artist 🙏
Further possibilities to support my free of charge models are:
|
👍 Many thanks for all of your support 👍 |
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)