Scallop Shell Electric Toothbrush Drip Tray
Print Profile(1)
Bill of Materials
Description
I designed a new toothbrush drip tray the last one I designed as a little unstable. This on holds the toothbrush flat. It's designed so that you can hang the edge over the sink so that as the toothbrush drips off after cleaning it it drips into the sink rather than making a mess on the counter when it's not being charged (if you share a charger). The space between the lines is slightly sloped to help it drain out the front. A brush can easily reach down there to clean periodically too.
There are 4 feet to keep the tray up off the sink surface and keep water from collecting under there. They should just interference fit into the holes, but a dab of glue shouldn't hurt.
The brim is there to keep the feet from flying everywhere when you break the parts free of the plate.
Boost Me (for free)
Any boosts are greatly appreciated! Most of these designs take a few iterations to figure out.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)