Pumpkin-Hana

Introducing the model Pumpkin Hana

Even if it's not Halloween season, a few pumpkins always look nice as decoration

The pumpkin model Hana comes with a pumpkin that can be either completely

_pumpkin.hana.body.full.(40|60|80|100).stl_

or as two halves
 

_pumpkin.hana.body.half.(40|60|80|100).stl_

printed

There are four different sizes 40, 60, 80, and 100mm. The size refers to (approximately) the height of the pumpkin. The pumpkin has a threaded opening at the top into which you can screw a stem

There is the stem without a hole

_pumpkin.hana.stem.solid.stl_

if you only want to display the pumpkin. The second version

_pumpkin.hana.stem.hole.stl_

has a horizontal hole so you can hang the pumpkin by the stem

You can print all parts without an AMS and still create a colorful variety

But sometimes it doesn't have to be that colorful at all

Further Notes

All models in the pumpkin series were designed by me, constructed with openScad, and printed and improved through many iterations. Each pumpkin has its own stem. However, the stems are compatible with the other pumpkins in this Pumpkin series

Tips for Custom Print Profiles

If you want to download the STL files directly (and not use my print profiles), here are some tips for you
 

The pumpkin (especially sizes 80 and 100) needs support at the base so it does not detach from the print bed. The internal thread of the pumpkin should always be printed without support, as it is very difficult to remove supports from the internal thread. (So it's best to use a support blocker.) The stems also need support and should be printed a bit slower, otherwise they will break too easily

More Models

I have another pumpkin model for you:

or if you are already thinking about Christmas, you might like the following model