Additional nozzles for Violent Fan X3 or similar

The power of this little fan still blows me away (pun intended). But mine came with only one nozzle. I wanted to have a few more practical nozzles/attachments, so i created my own in Shaper3D. 

For now, I've created 2 additional nozzles for this fan:

• 10mm opening for stronger airstream
• 8mm wider opening for more targeted airstream

All that is needed is a 10x3mm or 10x4mm magnet and a drop of superglue. 10x2mm isn't strong enough.

Instructions (read before printing)

1. Clean bed and start print. PLA will do fine.
2. The print will pause at layer 36 in order for you to insert the magnet.
3. Make sure you have the polarity of the magnet correct, otherwise it will not work.
4. Drop a small (!) drop of superglue in the center hole (don't smudge your bed with superglue)
5. Push the magnet in (check polarity!). I designed it to be a loose fit, so you don't have to press down on your bed too hard.
6. The magnet should pull itself down ass it's attracted to the print bed.
7. Resume the print.

I used this AliExpress shop for this item. But there are a lot of shops selling this item, even on Amazon. I'm sure they are all the same.

https://nl.aliexpress.com/item/1005008020189136.html?spm=a2g0o.order_detail.order_detail_item.4.2ab26d76qdBaFs&gatewayAdapt=glo2nld

Let me know if you have any feedback or requests.

Happy printing!