Lightburn Camera Mount: from Amazon
Print Profile(1)
Description
Makerworld has launched their commercial use program. I'm not sure what it will lead to but thought I'd give it a go. As a result all current and future models will have the commercial use option. Enjoy
This is a mount for an aftermarket Lightburn Compatible camera from Amazon. Lightburn is currently sold out so I needed a different option. The issue was, when the camera arrived it had a heatsink attached not shown so it needed a new holder. This uses M3 hardware for the nuts and caphead m3 bolts.
The design includes a method for aligning the camera on the center line as the camera is slightly offset from the board. The alignment is listed on the base of the model. There are two options, one with cable management for zip ties built in and one without. Labeled individually in the print profile. I also used some cable ties from Makerworld to run the wires which I'm listing below.
Camera used:
https://www.amazon.com/dp/B0BWS4R1BH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Cable mount zip tie plates:
https://makerworld.com/en/models/250357-cable-tie-zip-tie-mount-holder#profileId-266597
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (9)