Ring Clamp for ICTA Conduit Ø20 mm

This is a simple locking ring designed for ICTA conduit with an outer diameter of 20 mm.
It helps secure the conduit inside an electrical junction box, preventing it from moving or slipping out.

The part was modeled to fit snugly while still being easy to install. Just slide the ring onto the conduit and push it into the junction box.

Print Settings

• Material: PLA / PETG (PETG recommended for higher resistance)
• Layer height: 0.2 mm
• Infill: 20% is enough
• Supports: Not required
• Orientation: Print flat on the bed

Notes

• Designed for standard 20 mm ICTA conduits.
• You may scale slightly if your conduit tolerance differs.