TPU Dual 6mm Cable Grommet

TPU Dual 6mm Cable Grommet

Designed to adapt XD60i cable to a Costco Coho waterproof box. I used a commercially available  solar cable gland with built in M/F Solar plugs on the outside sealed with 3M tape for waterproofness. I had to splice the leads from those plugs to the XD60i pigtail and this grommet goes around the nominally (~.5mm) larger wires from  the solar plugs.

The grommet is designed to print without supports due to the upper lip being beveled on its bottom side. The grommet is designed with a .5mm slit on one side to make installation easier and allow a tighter fit around the cables. I used a flat head screwdriver and a small blunt tool to press the grommet into the hole in the box.

The Grommet should NOT be considered waterproof on its own.

Dimensions:

Outer diameter (flange): 22mm

Fits Hole size: 18mm

Distance bottom flange to base of bevel: 4mm

Distance bottom of flange to top of bevel: 5mm

Inner cable holes: 6mm

Slit: .5mm

Total height: 9mm