Search models, users, collections, and posts
model 3/Y radio mount
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
9
29
0
0
21
12
Released
Description
Designed for use with the Baofeng BF-F8HP, I haven't tested it with any other handhelds. It should work with any radio that has a clip under 1in wide. the fingers slot into small ridges just under the A/C vent. For the best fit you will need to find the first deep slot away from the screen, there are 4 or 5 that are only at half depth. press it in place and you're good to go. I printed out of white pla to minimize the heat from the sun.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)