[Parametric] Drain Cover / Hair Catch

 ⚠️ PETG: LET PLATE FULLY COOL AND REMOVE CAREFULLY! ⚠️

This flat drain cover / hair catch provides a thin mesh to place over larger holes to better catch hair while still allowing water and small particles to flow through easily.  By default, the mesh provides a 0.2mm-wide strand every 2mm, ensuring easy water flow while still catching hair that might clog your drain.

This model is parametric, so you can adjust it to fit your needs right in MakerWorld.  Adjust the diameter (130mm default), thickness (0.4mm default - half of the thickness is the mesh size), and outer ring size (4mm default).

Since the mesh is so thin, make sure to change your Wall generator to Arachne under Quality settings (only visible with Advanced enabled).

I recommend using PETG over PLA due to its improved water resistance, but note that PETG will stick to the build plate much more strongly, so you need to let the plate cool fully and be very careful when scraping the print off the plate.

Drop a comment if you need a specific configuration uploaded as a print profile so you can print from the Bambu Handy app.

All models uploaded to MakerWorld are uploaded with a free Personal Use License.  Commercial Use Licenses are available to Boosters (for the model Boosted) and Supporters/Distributors (subscribers on Patreon).

[License Details] [Patreon Memberships]