Rotating Telescopic Combined Glowing Double Blade, Short Knife, Light Stick, Signal Stick, Cheering Stick — Mini Printable

Model Introduction: Retractable Rotating Luminous Dual Blade, imitating a lightsaber's retraction and extension The extended length can be controlled When not extended, it can be handled freely The light blade will not fall out or retract on its own It can be used as a cheering stick or glow stick (one in each hand, waving with both hands) It can be used as a signal stick It can be combined for spinning play or used as a prop weapon: separated, it's a dual blade; combined, it's a double-ended blade The "spinning block" skill can be used (Combined length is about 70CM)

1. If you want it to light up like in the video, you need to buy two rechargeable mini flashlights, costing 8.6 yuan with free shipping The default flashlight size is 21MM If you need the same model for direct installation, you can search and purchase it according to the following pictures (see below) You can also modify the flashlight specifications in the model file yourself (diameters within 26MM are compatible) The model file has negative parts adjusted, just select and enter your flashlight size See the following pictures for specific modification steps After installation, you can directly charge, switch on/off, change brightness, and set constant light or flashing modes from the bottom of the blade

2. The color of the light blade depends on the filament color of your printed light stick component This model requires rotation and linkage If possible, please avoid using PLA Matte and PLA LITE, as they have lower strength and are not suitable for stressed components

3. The dual blade combination requires 16 strong magnets (default size is 5X2MM) You can modify the magnet specifications in the model file yourself (thickness within 3MM) The model file has negative parts adjusted, just select and enter your magnet size See the following pictures for specific modification steps

4. The black decorative parts of the model are glued Other parts are assembled according to the video The model can be disassembled after assembly, and worn parts can be repaired See the video for specific operations

5. Combining and retracting the dual blade simultaneously requires a certain technique: hold the cylinder part of both blades with one hand, and rotate the adsorbed bottom with the other hand (See the GIF below)

Dual-wielding usage, refer to the video below~

Method for combining and retracting the dual blade simultaneously (pinch both ends, rotate the middle part; the gesture might look a bit strange for clearer recording...), see the installation video for the rotation method

Method for adapting to other larger flashlight sizes (modifying negative part dimensions in the model file)

Method for adapting to other larger magnet sizes (modifying negative part dimensions in the model file)

Installation Video

Same model flashlight as below