X1/P1 Front Power Switch Extender - V2 with lock

This is X1/P1 version, other models also available:

Tired of reaching around your printer just to turn it ON or OFF? 

This simple but effective mod brings the power switch to the front of your X1 or P1 series printer. 

No more awkward stretching, no wasted space, just slide it under your printer and use!

This is upgraded V2 version with added lock and riser, front bump also have bigger and stronger thread.

Any Material – PLA, PETG, ABS… works with whatever filament you have, because there is no big forces on it. (set standard 0.2mm profile and change 5 walls and 5 top/bottom shells and 25% triangle infill) 

No Extra Parts or tools needed – no screws or any other hardware needed (in some cases you need superglue)

Easy Installation – just lift the right side of your printer slightly and slide it under

Space-Saving – no extra clearance needed at the sides or back

Hot-Swap Ready – can be installed even while the power cord is plugged in and printer is on.

Included Riser for Bambu Anti Vibration feet. (if your feet is lower you can just change vertical size for riser).
2 different switcher parts, choose the Left one if you have a 90° AC cord.

With this extender, you’ll always have fast and convenient access to your power switch — without changing your setup or disassembling  your printer. 
Additionally, if you want, you can print button from other color, and print ON/OFF letters.

Here is assembly video (sorry from V1 version without lock)

Have a look at my other models too!