PG7 Cable Gland Panel Mount Adapter (M12 threaded)

This is a simple adapter to mount a PG7 Cable Gland on a surface, using four M2 screws.  It comes in two heights, 8mm and 11mm.  

The 8mm version (shown in the pic below) will allow a mm or two of the cable gland to protrude, which should not be a problem since it would typically be mounted over a hole.  the 11mm version should fully cover the threaded end of the cable gland. 

This was designed for a specific project, but since I thought it may have more general uses, I decided to upload it here.  The STEP model is included for easy remixing.  Note that the M12 threads are not per the spec.  Rather, I started with a thread that was the right pitch and expanded the major diameter slightly, to accommodate the inherent surface roughness of FDM prints.  The model here is the 5th version I tested, and was able to be hand tightened most of the way, though it was snug and required a wrench to turn the nut on the cable gland the last 1-2 turns.

Use this model at your own risk.  It is up to you to decide if it is suitable for your application.  Feedback is welcome.

If you find these models useful, please post a like or a comment with some pics of your prints. 

You can find the other things I'm working on at my blog here.  You can also follow me here on MakerWorld, to see what new stuff I post.  If you would like to support my work, you can Buy Me A Coffee using this link:

https://www.buymeacoffee.com/mystoopidstuff

If you find these for sale on Amazon , Etsy or anywhere else, they are not being sold with my permission. There are no "authorized" sellers of these models. They were made for the 3D printing community, not for Amazon or Etsy sellers to profit from.

Thanks for looking!

Changelog:

8/16/2025:  Uploaded design.