Bambu Lab X1 Magnetic Poop Chute
Copyright Claim
Bambu Lab X1 Magnetic Poop Chute
Boost
167
332
187
Print Profile(4)
0.2mm layer, 3 walls, 15% infill
Designer
2.5 h
1 plate
0.24mm layer, 2 walls, 15% infill
2.2 h
1 plate
0.24mm layer, 2 walls, 15% infill
2.3 h
1 plate
0.24mm layer, 2 walls, 15% infill
2.2 h
1 plate
Boost
167
332
187
1
1.4 k
1 k
Released
Description
This poop chute catches the waste filament as it drops from the Bambu Lab X1 printer. This is a medium sized container. A larger version will be coming soon.
The poop chute uses a single magnet (0.5 inch diameter, 0.10 thick).
The recess for the magnet is modeled at 0.5 inches diameter so depending on your print, it could be an interference fit or apply some glue.
Filament - PLA+
Support - None
Layer - 0.2mm
Infill - 20%
3mf file using Bambu Lab Studio (slicer)new design is
UPDATE:
The design has been modified to accommodate the feet added to the X1, X1C, P1P, and P1S.
The new design is poop_shoot_magnetic_V2
Comment & Rating (187)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
Print went great!
1
Reply
super print profile
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
works and fits well, don't have any issue other than being small. But I like it small since it forces me to minimize the filament waste. Had to use two magnets since the the hole was deep or my magnets were too thin, but it attaches well.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed directly from the app. Fits perfectly.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
A low profile solution to keep the stuff off the floor. Works fine with or without mags because the tension of the fins keeps it in place.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed with black petg without any problems.
fits perfectly
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works well!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Came out great!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Prints great, looks nice and tidy and doesn't take too much space
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works perfect and is smal that you can mount it behind the printer when you have not enought space
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
I would have given 5*, but I had to cancel the print at the end. Filament stucked after printing. Everything Is ok.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (3)
Click to see more
Related Models
© 2024 MakerWorld