Magnetic Poop Chute Bambulab P1P / P1S / X1C

Remixed by

Magnetic Poop Chute Bambulab P1P / P1S / X1C

Remixed by
Boost
26
46
36

Print Profile(3)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.24mm layer, 2 walls, 15% infill
0.24mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
4.8(17)

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
2.3 h
1 plate
4.5(11)

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
5.0(1)

Boost
26
46
36
2
174
141
Released

Description

Modified Poop Chute. Removed the “Collar” inside the chute exit to minimize the risk of anything getting stuck, shortened it, widened the chute and changed the single magnet to 2x.

 

Magnet size is 7x3mm

Comment & Rating (36)

Please fill in your opinion
(0/5000)

excellent model - remixed for 8x3mm magnets
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
great print! only thing I would change in the profile is the z seam location. it would be much less noticeable if it was located on the back left corner.
The designer has replied
0
Reply
Thanks for the feedback. I do agree, however i unfortunately can't select that corner specifically and drawing it manually results in a somewhat squiggly line. Not sure what's better.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
This is perfect for my needs, it is not too large and holds plenty of poops. I used 6mmx3mm magnets that I had from another project with a little super glue and it really works well.
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
printed very well, thank you.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
nessy
0
Reply
Printed well and quickly (with Sunlu PLA using Bambu PLA Basic profile), awaiting magnets to arrive and install but it currently sits in place OK without them. Catches filament poop, large enough for my low printing volume.
0
Reply
Didn't fit 7x3 for me for some reason but was able use dremel to widen hole and glue one in. Thank you for the model remix!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
nice thank you
0
Reply