Woom 2/3 Samsung SmartTag2 Holder
Print Profile(1)
Bill of Materials
Description
I have made a holder for Samsung's SmartTag2 for the Woom 2 and Woom 3 or their respective saddles
Since the bikes are simply very expensive, I wanted a discreet solution for housing the tags here
I scanned the saddle and then modeled the appropriate holders That's why the one for the Woom 3 saddle is a bit uneven
But they fit perfectly and hold well
One print plate for each saddle-specific holder
Woom 2 Saddle (short stem with screws at the bottom rear) → Print Plate 2
The holder for the Woom 2 saddle is simply attached with the 2 original screws I also cut out an AirTag placeholder in this one However, I could only test the fit with a plastic dummy It is possible that further work is still necessary here The fit for my Samsung Tags is very good
Woom 3 Saddle (long stem no screws at the bottom rear) → Print Plate 1
The holder for the Woom 3 saddle is clamped at the bottom clamping ring for the reflector This must first be loosened Then the holder is inserted and the clamping ring is then re-secured Due to the precise fit and the nose, the holder cannot slip out
I printed both in PETG
They might also fit other Woom saddles, or I don't know if the saddles, for example, from Woom 2 also fit Woom 1, or Woom 3 on Woom 4
Have fun
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)