Search models, users, collections, and posts
Pokeball - Generation 2
Remixed by
IP Report
Print Profile(10)
Fast Ball - 0.2mm, 2 walls, 15% infill
Designer
2.6 h
4 plates
Friend Ball - 0.2mm, 2 walls, 15% infill
Designer
2.6 h
5 plates
Heavy Ball - 0.2mm, 2 walls, 15% infill
Designer
2.5 h
4 plates
Level Ball - 0.2mm, 2 walls, 15% infill
Designer
2.4 h
4 plates
Click to see more
Open in Bambu Studio
Boost
368
1080
128
41
958
560
Released
Description
See original model for assembly instructions: https://makerworld.com/en/models/839922-pokeball#profileId-785849
Profiles and models for the Generation II Pokeball designs. The lid geometries have been modified from the original design, but identical mounting alignment pin patterns make them inter-compatible.
Misc. Info:
- The print-in-place ring mechanism has two versions with different tolerances. Make sure your elephants foot compensation is set properly to prevent the hinge from seizing.
- The loose version has a minimum gap size of 0.3mm, and should work with most (non-bambu) printers
- The tight version has a minimum gap size of 0.2mm, and should only be printed if you are confident with your printer's capabilities
- The magnets I used measure 6mm x 1.75mm (6x2 nominal). I got them from amazon: https://www.amazon.com/gp/product/B07KJ9H31P
- Printable alignment pins are included, but you can use machined pins too
For Assembly Instructions and Troubleshooting Tips, see the original model
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (128)