Captin Pew Pew

cover

20250809_102039.jpg

20250809_102053.jpg

20250809_102157.jpg

20250809_102354.jpg

Screenshot_20250809_102720_Runcam Legacy.jpg

Screenshot_20250809_102749_Runcam Legacy.jpg

PLA Material

plate_1.png

PETG Material

plate_2.png

2025-08-09_24b4d47b36b0a8.jpg

All these settings below have this print completed in under 15 minutes!&nbsp;I suggest leaving the infill at 15%, as not much more is needed. If you want to increase strength, though, I recommend swapping the filament out for PETG or even ABS to ensure this sucker really doesn&#39;t break; should it get shot. However, PLA will work just fine, might want to replace it after 1-2 shots though.&nbsp;Change your top and bottom layers from Rectilinear to Concentric for a smooth finish on both ends of the print, with the honeycombs obviously on the plate.I would also suggest a smooth bed rather than the standard textured plate for a nice finish.&nbsp;Also, change your infill pattern from Grid to Cubic to save on filament, but also increase structural integrity and internal solid infill to Monotonic.

0.2mm layer, 2 walls, 15% infill

These camera&#39;s are made pretty robust, and I&#39;ve gotten lucky that mine hasn&#39;t been shot out over the years of playing Airsoft. I play as a Sniper, and I&#39;ve had my scope cams glare give me away at times. Figured this was a great way to both increase my stealth and protection for the camera.&nbsp;enjoy!<boostme><boosttitle>Boost Me</boosttitle><boostcontent>If you think this is awesome, you should see some of the other things I&#39;ve made. :p</boostcontent></boostme>

Runcam Scopecam Killflash / Protector

ASIA

Print Profile(1)

Description

Comment & Rating (3)

License

Related Models