Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
2
4
0
0
4
0
Released
Description
A bigger housing for the bottom fan of Lian Li's q58 case, fits a standard sized 120mm fan and attaches to the same spot as the original fan cover for a low profile fan.
My PSU had too stiff cables to allow even a low profile one, so I decided to make a cover for a full sized 120mm fan.
NOTE: Due to the height of the casing, this won't fit under your case unless you also print taller feet as seen in the full case photo. You can find that print here https://makerworld.com/en/models/1678036-lian-li-q58-higher-feet
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)