Snap-On Cheesehead

Snap-On Cheesehead – Because Every Hat Deserves a Slice of Glory 🧀

Never be caught cheese-less again! The Snap-On Cheesehead is the ultimate upgrade for any baseball hat, turning your everyday cap into a proud, cheddar-powered crown. Designed with a universal, changeable snap size, this cheesy champion fits snugly on any hat—no need to print a whole new wedge every time you swap lids.

Whether you're tailgating, grilling, or just living your best dairy-loving life, your trusty Cheesehead is always just a snap away. Lightweight, secure, and outrageously fun—this is cheese fashion at its finest.

I have included 3 different sized snaps that thread onto the cheese as the handful of hats I own had a few different size snaps on top. I added a S,M,L for small, medium and large to the slicer but the letters being so small they don't seem to print well but should help you find the size that works for you and the snaps still work without the little letter on them.

Update*

Added a second profile with even more snap size options along with the snap size on each adapter. I found that the snaps can flex with PLA pretty easily .3mm so I made multiple steps up and down at .3mm intervals. My largest hat snap measured 16.7mm and the 16.7mm adapter works but feels a bit loose for jumping up and down or moving around. I put the 16.4mm snap on that hat and it went on with no problem and was still easily removable but held tight while wearing.

Just added a Creeper head that uses the same adapter so no need to print another adapter just need to print the Creeper Head if you want to switch between them

https://makerworld.com/en/models/2763217-creeper-head-snap-on-hat#profileId-3068086