Search models, users, collections, and posts
Crack Clamp
IP Report
Print Profile(1)
0.28mm layer, 5 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
3
17
1
0
16
13
Released
Description
This is my version of a StewMac crack clamp. If you need a crack clamp, I highly recommend purchasing them from StewMac, but in my case, I needed one quickly and couldn't wait for shipping. But, seriously, I can't recommend StewMac enough.
I've printed a few of these, one at 35% in PLA, one at 100% in PLA, and one at 25% in ABS. They don't need a lot of force, so there's not a need for a lot of reinforcement. Also, this is sized for a 10mm tuner key.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)