Search models, users, collections, and posts
8 Position Phone Stand
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.9 h
2 plates
Open in Bambu Studio
Boost
3
5
0
0
8
0
Released
Description
I created this 8 position smart phone stand to be quickly adjustable, print in place without supports, and to be a pretty quick print (2 hours for me). It has spots for 4 rubber feet (less than 10mm in diameter, but should be 2mm tall).
It folds down for easier travel.
I have included 2 styles. One with a diamond pattern, one without. Both stylesWITHOUT supports!
Please post your makes and comments!
Print Settings
Printer:
Hatchbox Alpha
Rafts:
No
Supports:
No
Resolution:
0.20mm
Infill:
20%
Post-Printing
How to use
When you remove it from the build plate, move the back support forward to break it free from the base (if it's fused at all). It should move pretty freely.
Then just slide the back support up and back to the desired position. Adjust fore and aft to adjust phone tilt.License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)