Search models, users, collections, and posts
Lushan K230 Bracket (Hole Alignment)
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
54 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
21
0
Released
Description
Content has been automatically translated.
Lushan K230 hinge bracket for the Lushan series. Simply remove the front transparent acrylic shell of the Lushan and replace it with this bracket. The screw holes are pre-aligned. If any screws are difficult to tighten, slightly loosen the other screws and then tighten them sequentially. The hinge supports hinges with a 10mm hole spacing. Supports are enabled and the settings are optimized in the default print configuration. Print directly.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)