Carnaval Festival phone stand | Efteling

Note: All my models are for personal use only and may not be sold!

Fancy a nice looking phone stand?

Try this one!

This phone stand is a recreation of Carnaval Festivals ride vehicle at Efteling.

You can use it to display your phone and charge it as well!

Every phone model should fit. The smartphone in the photos is a iPhone 15.

And you can use it ofcourse to display some other pieces.

Or perhaps you like to print all of the colours of the actual ride ;-).

Change the colours to your preferred choice.

Please note

The added photos are showing the prototype version of the model.

After printing it I've added the following:

• Extra design elements on the sides of the coloured backdrop
• Other supports to make it look more ‘clean’ on the overhanging parts
• The figure on the back (Jokie) did not have the right mouth, now it does
• Jokie had some flat pieces on his hat, this has been fixed as well

You're printing the best version!

Print plates

This model contains 3 buildplates with a total of 6 printed pieces:

• Plate 1: black base
• Plate 2: coloured backdrop and front piece
• Plate 3: coloured accents

Installation guide

Most parts will just click together. You can add some glue to make the model even stronger.

Step 1

Click the base inside the coloured backdrop. Push it down to secure is into place.

It doesn't require glue, it is being held by friction.

Step 2

Click the front piece into place. I recommend to add some drops of glue to make it stronger.

Step 3

Add the small accent on top of the front piece.

This part does not have a connection part so glue is required here.

Step 4

Add the two big accent pieces. These two will click into place.

I recommend to put a drop of glue in between the two pieces at the top.

This will make it look more ‘clean’.

You can choose to add more glue but I didn't do that myself.

Check out my other Efteling related models as well!