Radxa Zero 3W/3E Case

A smooth and clean enclosure with hex ventilation holes for the Radxa Zero 3W and 3E:

https://radxa.com/products/zeros/zero3w/ 

https://radxa.com/products/zeros/zero3e/ 

• Prints in 3 parts (top middle and bottom) and 4 legs that slide into the bottom piece (this decision was made to make the bottom face print smoothly from the bed)

• The GPIO is exposed for easy prototyping work with it.

• It has been carefully designed to be assembled without any screws or threaded inserts, optionally 2 M2.5 3mm screws and threaded inserts can be used to securely mount the board

• The top piece is somewhat loose but I think it's fine so long as you are not violently shaking it

• This case is also compatible with the 3E version's ethernet port however I do not have one to test out its success of fitting.

• 30mmx30mm 5V DC fan cannot be fitted within but it can be placed above the top piece for sufficient ventilation if using Radxa's 5519A heatsink: https://radxa.com/products/accessories/heatsink-5519a/ 

Support my work: https://ko-fi.com/leafygg