Search models, users, collections, and posts
Print-in-Place 3-Jaw Chuck for Painting Miniatures
IP Report
Print Profile(3)
For 25mm Bases. 0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
For 40mm Bases. 0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
For 50mm Bases 0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
3821
10147
632
497
6 k
3.7 k
Released
Bill of Materials
Bambu Filaments
Select all
Description
Version 2 is out now, check it out → here ←
Essential Tool for Painting Minis
A print-in-place 3-jaw chuck built for miniature painters. It holds your figures securely, allowing for improved control during brushwork. No assembly or supports are needed.
After printing, lightly push each jaw side-to-side as shown below.
Then firmly rotate the center part either direction until it clicks free.
Now it should freely spin around, opening up spinning one way, and closing in rotating the other way.
Boost Me (for free)
If you enjoy this model, a boost would be very much appreciated!
Comment & Rating (632)