Search models, users, collections, and posts
Print Profile(2)
#1 - 0.2mm layer, 2 walls, 8% infill
Designer
8 h
1 plate
#2 0.2mm layer, 2 walls, 8% infill
Designer
13.1 h
1 plate
Open in Bambu Studio
Boost
1670
3375
113
86
2.2 k
825
Released
Description
Cyberdemon Can Holder (two types)
Fits long EU cans with a capacity of 0.5L. You can also use my insert for 12oz or 330ml (slim) cans (link below)
Recommended print settings: PLA, 0.2mm layers, 2-3walls, 8-10%gyroid, Automatic Tree supports (at least 26°), block supports inside the mouth - behind the teeth, or just use my profiles.
Be careful with the supports, remove them very carefully in the area of the teeth. I recommend using small pliers.
#1
#2
Here is the link to my model of the insert that you can use in 0.5L holders with your 12oz , or 330ml slim cans, and 10mm riser if you want better access to the top. Both are scalable, so you can make them smaller or larger in your slicer.
Happy printing:)
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (113)