Paper towel holder

This model is a two-part, bolt-reinforced kitchen paper towel holder.

I've noticed that many holders simply clip onto cabinet doors, which is clearly inadequate; a slight amount of force causes them to slip, leading to the paper roll falling out.

Due to this lack of stability, secure fastening with bolts is necessary.

I have employed an 88° angle design with a dual-secured bolt fastening, and incorporated R3 rounded corners internally to prevent stress concentration, as shown in the image below. This design can accommodate boards up to 20mm thick.

Finally, my kitchen paper towel specifications are an inner diameter of 35 and an outer diameter of 120. If you require other sizes, please leave a comment below.

Note: The right side features a right-hand thread, while the left side uses a left-hand thread. The bolts are not interchangeable, as the left component was created by mirroring the right one.

I will upload all STP files.