 what is missing in this picture,  I printed it out but the base of the Vise, there is nothing to attach the base to the ball.    Also your ed preview  is wrong compared to the what is downloaded.  the last picture in the 3d print shows a different moving clamp with groves.  That is not in the 3d Print profile.   

what is missing in this profile that attached the vise base to the swiveling ball joint


nixdesignworkshop

Dahoon

3 walls and modifiers. small clamp version(52mm)

Yes the large clamp for thick tables. But you can still assemle a vice with the smaller clamp, so no missing part ;) 

CippyO

only needed 1 part that broke from a version I printed a few years ago and it still fit perfectly with the existing parts

Denniz

DannyApp

Zheng

4Dtinker

EngGraph

Iliyan Mavrov

cover

NanoViseV2_CLAMP_BALLJOINT_DeskClamp_Version.png

NanoViseV2_CLAMP_LONG_DeskClamp_Version.png

NanoViseV2_CLAMP_NUT_DeskClamp_Version.png

NanoViseV2_CLAMP_rep_DeskClamp_Version.png

NanoViseV2_CLAMP_SCREW_DeskClamp_Version.png

NanoViseV2_CLAMP_SCREW_HEADPLATE_DeskClamp_Version.png

NanoViseV2_VISE_BASE_Rev_DeskClamp_Version.png

NanoViseV2_VISE_SCREW_DeskClamp_Version.png

NanoViseV2_VISE_SLIDER_Type1_DeskClamp_Version.png

NanoViseV2_VISE_SLIDER_Type2_DeskClamp_Version.png

plate_1.png

IMG_20250803_093236.jpg

IMG_20250803_093359.jpg

IMG_20250803_093416.jpg

basic settings:0.2mm layer heightAracne wall gen15% gyroid infillsingle perimeter top layer turned off for some parts, as well as i set to concentric top fill for the screw and nut partsthe C clamp itself, i found 3 walls with 15% infill to be too flexible, so i set it to 5 walls and 35% gyro infill&nbsp;Overall it&#39;s a great model, and works very well. I used an m8 by 20mm hex head screw, and i needed 2 m8 washers, overall about 3mm thickness. or you can use the advised shorter screw but i only had this on hand, and didn&#39;t wanted to cut it.&nbsp;Printed it on the a1 mini with the smooth pei plate, and the adhesion was way too good, and at the same time, the bottom overhangs of the main body melted a bit, so one might want to consider to lower the bed temps, to solve both problems.&nbsp;Currently printing some tpu boots that i designed for this vise, and will upload them as a remix.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.

This user content is licensed under a Standard Digital File License.

DESK CLAMP VERSION What&#39;s completely new here is the C-clamp which includes one ball-joint system where the shaft is fixed by a M8x10mm Allen screw (with cylindrical head) to the vise base bottom.

Nano Vise

ASIA

Print Profile(1)

Description

Comment & Rating (8)

License

Related Models