Search models, users, collections, and posts
Elegoo Centauri Carbon Hinge Gasket
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
59 min
1 plate
Open in Bambu Studio
Boost
63
126
0
2
134
7
Released
Description
Boost Me (for free)
I'd appreciate if you could spare a boost to help keep me motivated to do more for you all.
For those that are trying to seal their Centauri Carbons for heat retention, this little gasket should help. The hinge pinches tighter as you close the door and open the door so I fit it best I could.
Please have your tpu dried and dialed in and this'll be easy to print. As always with these machines tolerances and fit may vary.
TPU seal is held in by 4 strips of ½" 3M Scotch VHB tape x60mm long
https://www.amazon.com/dp/B01BT0A6MG?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1
Let me know if there's a problem and I'll try to accomodate.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)