Ultimate Miniature Wet and Dry Palette

This is my take on the ultimate dry and wet palette for miniature painting. The design includes a bottom section with built in storage. Then on top of that section slots in the wet palette. It can be used on top of the bottom section or removed as needed. The top section includes a dry palette insert that should fit tightly enough to not fall out but no so tight that you couldn't take it out in the future. I printed the dry palette separately so I could use a 0.2 mm nozzle to get the details. The dry palette does take almost a day to print but I think its worth it. 

If you print at a higher layer height or with a larger nozzle be aware that the model will be rougher on your dry brushes. You may want to sand it down a little bit.

I printed with some mildly ugly PCTG filament because I had it laying around but the main parts should be printed with PETG. PLA would probably be fine for everything except the wet palette insert which should be PETG to ensure that it is water tight.

The wet palette is designed around this sponge and wet palette sheet set from Amazon.

https://a.co/d/gZgjJco

The dry palette may look familiar to anyone who has downloaded my previous dry palette.

Below are the public domain models used to create the dry palette. Thanks to those modelers for sharing!

https://www.thingiverse.com/3dfactorymx/designs

https://www.thingiverse.com/happychippy3/designs

https://www.thingiverse.com/coichikwakwakwkwak/designs

https://www.thingiverse.com/pipoden/designs

https://www.thingiverse.com/ogver/designs

https://www.thingiverse.com/valandar/designs

New Airbrush practice palette - https://makerworld.com/en/models/2121871-airbrush-practice-palette-and-stencil#profileId-2296870