Search models, users, collections, and posts
Servo Cable Lock
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
117
257
34
19
448
310
Released
Description
This model is designed to hold connectors used on Servo Extensions together. It is designed to fit over the connector, and hold it secure in place, preventing the connectors from coming apart. This model is designed with very thin sides to keep the mass down, it is recommended to print this in PETG, so that any flexing will not cause the lock to break. I have printed in both PLA and PETG, but do not have enough long term time with the print to know which will work best over time.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (34)