Cup holder and drip tray, freely combinable cup holder, practicality first

Must do before printing:

• For models with large base areas, please make sure to clean the build plate before printing

--------Update Divider--------

The rounded corners on the outer bottom of the tray have some overhang issues, I use P1S, when printing the rounded parts with PLA material, there are layer lines, but the overall appearance is neat and rounded, for your reference

To make printing easier, the print profiles for three sizes have been updated

Optimizations are as follows:

• The outer rounded corners at the bottom of the tray have been changed to right angles
• Removed the support at the top of the cup holder, actual testing showed no impact
• Changed infill pattern to spiral - 10%

Please note, the top dimensions of the long and short cup holders are different, pay attention to the part names when combining them freely for printing, pay attention to the part name, part name...

--------Update Divider--------

• Added 180*90mm, 180*170mm sizes, printable on A1 mini

--------Update Divider--------

Model Features:

• The cup holder and drain tray are assembled by combining parts, allowing for repositioning and free combination
• Two types of cup holders are provided, one approximately 14cm long and one approximately 8cm short, print as needed

• The top of the cup holder has been separated for easier printing and a more aesthetic appearance

  Pictured cup dimensions: Tall 70*130mm / Short 83*73mm

Please note, the dimensions of the long and short cup holders are different, pay attention to the part names when combining them freely for printing, pay attention to the part name, part name...