Business Card Embosser Cat Face Rollers - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

Emoticon

Household>Office

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.16mm layer, 3 walls, 15% infill

Designer

1.5 h

1 plate

4.6(20)

Open in Bambu Studio

Boost

520

1288

607

243

Released

Description

I printed this business card embosser for my daughter to play with. I was dismayed to see that the cat roller in the picture was not included with the project files so I reverse engineered the roller and made my own with a cat face. I found I had to change the orientation of the rollers a few times because of the backlash in the gears of the original design, but once you find the orientation that works best it makes a nice impression.

Here is a link to the original project. The information in his build guide should apply the same.

Business Card Embosser - Level up your business cards! by Makerspace.Online - MakerWorld

Comment & Rating (31)

@HappyMango3D

Boosted

Print Profile

0.16mm layer, 3 walls, 15% infill

Very nice pattern :)

@GyuLee

Maybe because the pattern is thin, the pattern doesn't come out well on my business card.

The designer has replied

@Emoticon

Its very important that both rollers mesh perfectly to get a good impression. if they are misaligned even a little it wont make a deep impression. Usually I assemble the gears and the rollers together and slip both rollers in together at the same time to make sure they stay meshed and don’t misalign while installing them into the housing. Also try flipping the rollers as well. Some papers do work better than others, in the photos Im using 300 GSM card stock which is pretty thick. Ive also tried 284 GSM card stock too. Make sure as you crank that the housing isn’t separating either.

@NotForEveryone

Replying to @Emoticon :

Yes the alignment is very important but that is the issue. After printing it it does not align perfectly in any orientation. If you roll it slowly you can feel it jump over the sides of the face for example but there are other issues too.

@Emoticon

Are you printing in sport or ludicrous mode or maybe using a temp on the high side that you may be getting filament expansion or slumping? here they are meshed and held up to the light. They mesh in all 5 faces.

@SusiKnalltuete

Print Profile

0.16mm layer, 3 walls, 15% infill

The print looked good and was okay, but overall the entire part did not work. Even thin paper blocked the rollers. And unfortunately, the knob always skips at the top. Too bad, I disposed of it immediately

Show original

@antoniaher1968

Print Profile

0.16mm layer, 3 walls, 15% infill

so cute!

@printgeluk

Worked well enough for me with the Bambu basic PLA! Did have to align the rollers after printing by looking which cat face is parallel to a square edge (of the top hole of the roller) then it’s easy to align!