Search models, users, collections, and posts
Front Panel Door for Sanyo VTC-M20 Betacord
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
2
0
0
0
3
0
Released
Description
This print has been tested on the Sanyo Betacord VTC-M20 but I believe it may work on the VTC-M10 too.
It fits nicely with visibility to the power light as well as still being able to move the tracking dial when its shut. I'm very much an amateur at 3d modelling and had no existing part to replicate so it's an original basic design.
I've printed it using standard PLA with a P1S and smooth plate for a similar finish to the rest of the device.
Hopefully it can tidy up your Betacord!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)