Car Wind Tunnel

The AC in my Mazda went out at the end of last year and they estimated it would be over $2k to fix it. Not wanting to spend that much, I drove the car with my hand out the window to funnel some air into the cabin. As I live in Florida and summer has kicked in full swing, I needed an upgrade. This model is designed to act as a little wind tunnel to keep you cool while you drive. I have only tested it up to 30mph so far. Please use with excessive caution. I am NOT responsible for any damage!

There is a little slot to add an ice pack if you feel so inclined. I didn't notice too much of a difference, but thought I would leave it just in case.

I definitely recommend printing this in PETG at a minimum to deal with heat.

The full size model has to be printed on the H2D, but I included a split model that can be printed on the X1C or A1 (I used both) and can be glued together.