CompanionPi4 StreamDeck Case

A remix of the CompanionPi – StreamDeck Enclosure modified for the StreamDeck MK1 and MK2 (15-button) models.

A while ago I found the CompanionPi - Streamdeck Enclosure from nominari on Thingiverse. It works great with a StreamDeck XL but I  had an old MK1 laying around and thought it would be nice to adapt the enclosure for it. So I made this remix and created a StreamDeck MK1 and 

Main changes:

• Holes for 3M Bumpon 8 mm feet
• Hole for a 1/4" heat set insert on the bottom
• Adjusted Pi mounting holes for better Ethernet clearance
• Extended front for improved cable management and a closed look
• Updated ventilation hole design
• Diagonal texture on side and front walls
• Moved rear tab to the top for easier dual-color printing
• USB-C power connector cutout (tested with official Pi4 PSU)
• LAN & Power labels added

Materials: Works well with PETG or ASA. PLA should be fine for indoor, stationary use but be aware the Pi could get warm.

Parts needed:

• 1x Elgato Streamdeck MK1 or MK2 (*) (15-Buttons)
• 1x Raspberry Pi4 (*) to run Bitfocus Companion. 
• optional 1x Waveshare PoE Hat (E) (*)
• 1x D-Type Ethercon connector
• Heat Set Inserts:
  • 4x M2.5 (for Raspberry Pi) - LINK (*)
  • 8x M3 short (for top and back) - LINK (*)
  • 4x M3 (for Streamdeck Mount) - LINK (*)
  • 1x 1/4"S (for bottom mount point) - LINK (*)
• countersunk screws:
  • 4x M2.5 x 8mm (for Raspberry Pi)  - LINK (*)
  • 4x M3 x 8mm (for back)
  • 4x M3 x 10mm (for top)
  • 4x M3 x 25mm (StreamDeck MK2) OR 4x M3 x 18mm (StreamDeck MK1)
• 1x short RJ45 cable (ideally angled on one side) - LINK (*)
• 1x short USB-A to USB-C cable for MK2 version
• 4x rubber feet 8mm (3M Bumpons) - LINK (*)

🔗 * Affiliate Links – Purchases made through these links help support my work, at no extra cost to you.