Beer Darts “White-Water BeerRaft” Add-On

Beer Darts “White-Water BeerRaft” Add-On
A fully sea-worthy 3D-printable raft that cradles your Beer Darts set (and beer) for epic pool, lake, or river adventures—complete with oar-lock dart holders!

🛶 Model Overview

• Form: Twin-tube white-water raft with flat center “deck” sized to snap-fit your Beer Darts base and standard 12 oz can.
• Capacity: Fits one Beer Darts set + 1 can(s)
• Dart Storage: Four integrated oar-lock posts (one per side), each sized to grip a dart shaft like an oar.

🔧 Key Features

1. Snap-Fit Beer Cradle
   • Central recess exactly matches the Beer Darts inner hull.
   • Low-profile magnets (optional) secure set during choppy splashes.
2. Oar-Lock Dart Holders
   • Standard Ø8 mm posts with 20 mm tall collars.
   • Press-fit tolerance holds dart barrels; release by pushing up from below.
3. Drainage Channels & Buoyancy Walls
   • Slotted deck drains splashed water back into the raft tubes.
   • Reinforced inner ribs under deck for rigidity.
4. Grab Handles & Tie-Down Slots
   • Two ergonomic hand grips.

🖨️ Print Settings (PLA or PETG)

• Nozzle: 0.4 mm
• Layer Height: 0.2 mm
• Infill: 5% Hex
• Walls: 4 perimeters for tube strength
• Supports: Only under oar-lock posts and tube-to-deck junctions

🧩 Assembly & Use

1. Print the single-piece raft shell and two oar-lock posts.
2. Press each post into its socket until flush with the rail.
3. Seat your Beer Darts set into the central cradle
4. Load your darts into the oar-locks.
5. Launch on calm water, grab your paddles (or actual oars), and let the fun begin!