X-Shot Longshot Pusher Reinforcement

Simple yet highly effective! This reinforcement prevents your X-Shot Longshot Pusher from breaking.

Did your pusher already snap? Print, push, glue, and you're back in action. If it's still intact, print and install this reinforcement for worry-free foam fun.

I printed mine in PETG, but PLA+ works flawlessly too.

For my print settings, I used 3 walls and 20% gyroid infill, with tree supports.

The O-ring is absent from the picture because I'm using the Sabre system and didn't have a spare. However, do NOT remove your O-ring from the pusher.