OnePunchMan Panel

Made a few Hueforges of my favorite manga panels with the inland PLA+ I had lying around. Please pay attention to the Transmission Distance (TD) of my filaments so you can use a filament of similar TD to get similar results. 

OnePunchMan Panel illustrated by ONE, Yusuke Murata

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 140.66x200mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 3.2mm and the Actual Thickness is 3.2mm

Filaments Used:
    #080a0d PLA Inland Black Transmission Distance: 0.3
    #4d4d4d PLA+ Inland “Darker” Grey Transmission Distance: 1
    #adadad PLA Tough Inland Cosplay "Lighter" Grey Transmission Distance: 2
    #ffffff PLA+ Inland White Transmission Distance: 2

This print uses 4 unique filaments

No-AMS:

Swap Instructions:
    Start with Black
    At layer #14 (1.2mm) swap to “Darker” grey
    At layer #21 (1.76mm) swap to "Lighter" Grey
    At layer #28 (2.32mm) swap to White for the rest.
 

I do NOT own any rights to this panel or anime/manga in file.
OnePunchMan is Japanese manga series written and illustrated by ONE, Yusuke Murata.