Gridfinity Tapcon Tool Organizer

I frequently use Tapcon concrete anchors at home for mounting just about anything to concrete walls (pre-cast or concrete block), but it was always a pain to track down the various drill sizes and driver bits needed. Additionally, there were more than a couple times that I would accidentally use the larger size drill bit and only realize my mistake when I tried to install the anchor and it just slipped in the drilled hole.

These blocks each fit on a 1x3 Gridfinity footprint and include labeled dedicated spots for each tool required for installation (drill bits, the Torx bits for installing the countersunk fasteners, and a hex driver for the more common Hex drive fasteners). Each block is labeled with the corresponding fastener size which the tools should be used with.

I left Gridfinity standard magnet holes in the corners of each block if you want to use them, but personally I never do.