Necropolis tiles (OpenLOCK system)

Nothing screams “LETS GET OUT OF HERE!” as a floor paved with skulls of previous victims.

A temple in hell? The room of a necromacer? The house of a cult? So many posibilities!

Instructions:

• Print the tiles of your choice.
• Remove the small supporting pins on the sides.
• Print Openlock clips to connect the tiles.
• Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).
• Connect the tiles together.

Looking for the other designs to build your own necromancer lair? Use these components:

• Necromancer tiles
• Necromancer walls
• Necromancer corners
• Necromancer brazier
• Necromancer round altar
• Necromancer big altar
• Necromancer round big pillar
• Necromancer square pillar
• Scenery: pile of bones

I remixed the original tiles adding an Openlock triplex base you can click the tiles together in a limitless configuration of your choice. This way you can build the terrain easily and don't have to be scared the tiles get pushed around.

I added aditional beams, because I found that printing the big ones without them gives a very bad texture at the bottom. And if I put the time and money in tiles, I want them to be pretty and sturdy.

I also made the tiles bigger, and without a border to make the room more open.

Together 3D has a commercial license for using the OpenLOCK system. More info can be found on www.printablescenery.com