Tainted Grail Mini Menhir

[Attention] The counter must be printed separately. It is designed to fit @Zaje 's counter.

This is a mini menhir that replaces the Tainted Grail menhir figure.

If you only want to replace the figure, you can print and use the stand version.

If you want to use the counter together, print @Zaje 's counter below, and print other parts except the cover.

https://makerworld.com/en/models/1338183-1-digit-counter#profileId-1378021

Then, print the Counter Cover Ver located on plate 2 of this file and assemble it.

When removing supports from Counter Cover Ver, if you use a thin or sharp tool to pry off the seemingly blocked bottom part, as shown on the right side of the photo, the infill support will be removed. The left side shows the removed form. You may injure your hand during this process, so please proceed as safely as possible.