Cosplay Werewolf Ears

Hi, 

    here are my Werwolf Ears! I use these when its not a full Moon. I went through many versions and ideas to get to these. Please bear in mined they are design for my head size so you might have to scale them up or down a bit to fit. 

I printed them 0.2mm standard with supports on bed only and a brim. I set inital layer expansion and brim width to 8mm. Make sure you paint on some supports especialy under the ear loops and up the ears so they dont wobble when printing. 

Paint, I used Dulux difficult surface primer on the inside of the ears, serveral coats with wet and dry sanding inbetween. I painted on some Acrylic dark red veins with a brush and sprayed on some pink Acrylic shades using my airbrush. You could brush on coats on or use can spray paint. All the paint I used is water based.

 For the fur effect I bought some cheap fake fur from Amazon, glued it on with contact adheasive and shaped it with some hair clippers. There are tutorials on youtube for this procedure.

 The ears pug into the head band so you can rotate them or glue them in if you wish.

I hope you have fun making them!

R.W.W.  

https://www.instagram.com/reel/DJ4YhJBCYcC/?igsh=MW96MWhzOGdjZnB2Mw==