Search models, users, collections, and posts
Jetflame Blow Torch Lighter Holder (61mm foot) for Skadis
IP Report
Print Profile(1)
0.2mm layer, 3 walls, pegs with 100% concentric infill, no support
Designer
38 min
1 plate
Open in Bambu Studio
Boost
12
47
15
4
76
58
Released
Description
Update 2024-01-29:
Since I wasn't very happy with the stability this model I made a new version!
A Skadis holder for a those big jetflame blow torch lighters with a foot diameter of nearly 61mm.
No support needed. Just take care that the pegs are massive.
In the print profile I used a modifier to increase to infill to 100% concentric.
The holder is quite flat, so I recommend using the Skadis Lock Plug (9mm) to prevent the holder from sliding out of the pegboard holes.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (15)