Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
39 min
1 plate
Open in Bambu Studio
Boost
10
14
0
1
20
8
Released
Description
I couldn’t find any models that matched my setup, so I remixed maggoh's design. I extended the enclosure, added a slot for the antenna, and resized the lid opening to fit the LD2410C snugly inside. I also adjusted the cutout for the ESP32-S3 to ensure a tight fit and proper alignment with the USB-C port. Printed in PLA from Sunlu on Amazon.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)